Autonics CT6M-2P4 - Table of Contents

Table of Contents 나
x © Copyright Reserved Autonics Co., Ltd.
6 Basic Operations (Counter/Timer/Communication) ............................... 39
6.1 Operations and functions ................................................................................... 39
6.1.1 Setting value change mode (Counter/Timer) ............................................. 39
6.1.2 Setting value check mode .......................................................................... 40
6.1.3 Switching display function in preset indicator............................................. 40
6.1.4 RESET........................................................................................................ 40
6.2 BATCH counter (only for CT6M-1P□□/CT6M-2P□□ model) ...................... 40
6.2.1 BATCH counter operation .......................................................................... 41
6.2.2 BATCH counting operation ........................................................................ 41
6.2.3 BATCH output operation ............................................................................ 41
6.2.4 BATCH RESET input ................................................................................. 41
6.2.5 Example of BATCH counter ....................................................................... 42
6.3 Setting mode ...................................................................................................... 43
7 Counter Mode ............................................................................................ 45
7.1 Parameter Setting .............................................................................................. 45
7.2 Input mode ......................................................................................................... 47
7.3 Output mode ...................................................................................................... 50
7.4 Counter operation for indicator model ............................................................... 53
7.5 Output operation for other conditions ................................................................ 54
7.5.1 Start point ................................................................................................... 54
7.5.2 When start point value is larger than setting value,
(UP, UP-1, UP-2, UD-A, UD-B, UD-C mode) ......................................... 54
7.5.3 When PRESET 1 is larger or equal than PRESET 2 at down mode ......... 55
7.6 Prescale ............................................................................................................. 56
8 Timer Mode ................................................................................................ 57
8.1 Parameter setting .............................................................................................. 57
8.2 Output mode ...................................................................................................... 59
8.3 Timer operation for indicator model ................................................................... 67
8.4 Timer ‘0’ Time Setting ........................................................................................ 70
8.4.1 Available output mode to set ‘0’ time setting .............................................. 70
8.4.2 Operation by each output mode (‘0’ time setting) ...................................... 70
9 Communication ......................................................................................... 77
9.1 Parameter Setting (Counter/Timer) ................................................................... 77
9.1.1 Communication address [
ADDR
] ................................................................ 78
9.1.2 Communication speed [BPS] ...................................................................... 78
9.1.3 Communication parity bit [PRTY]................................................................ 78
9.1.4 Communication Stop bit [
STP
] ................................................................... 79
9.1.5 Communication response waiting time [RSwT] .......................................... 79
9.1.6 Communication write [
COmW
] ...................................................................... 79
9.1.7 Application of system organization ............................................................. 80
9.2 Software (Comprehensive Device Management Program: DAQMaster) ......... 80
9.3 Parameter value read/write via communication ................................................ 81
9.4 Communication control ordering ....................................................................... 82