Autopilot Pool Pilot Digital Nano+ - Select Units; Set Temperature Unit; Display Temperature; Set 12;24 Hour Clock (Optional Feature W; 863 A Expansion Board)

Page 24
7.6.5 Select Units
Used to program the operator’s personal preferences for the liquid and weight measurements
the Digital Nano/Nano+ will display.
1) Press MENU, press or until “Owner options” or “Installer menu” is
displayed; then press SELECT.
2) Press or until “Select units” is displayed; then press SELECT (“English
units” is the factory setting).
3) Press or until desired measurement “English units” (gallons and pounds), or
“Metric units” (liters and kilograms), is displayed; then press SELECT.
4) Press or until “End menu mode” is displayed; then press SELECT.
7.6.6 Set Temperature Unit
Set personal preference for temperature display units (°C or °F).
1) Press MENU, press or until “Owner options” or “Installer menu” is
displayed; then press SELECT.
2) Press or until “Temperature unit” is displayed; then press SELECT
(“Fahrenheit” is the factory setting).
3) Press or until desired measurement unit “Fahrenheit” or “Celsius” is
displayed; then press SELECT.
4) Press or until “End menu mode” is displayed; then press SELECT.
7.6.7 Display Temperature
Choose to either show or hide the water temperature on the normal display screen.
1) Press MENU, press or until “Installer menu” is displayed; then press and hold
SELECT (approximately 13 seconds) until “Installer menu” is displayed again and
is accessible.
2) Press or until “Display temp” is displayed; then press SELECT. (“Show
temperature” is the factory setting.)
3) Press or until “Show temperature” or “Hide temperature” is displayed;
choose desired option and then press SELECT.
4) Press or until “End menu mode” is displayed; then press SELECT.
Note: Even if the Display Temp feature is turned off, the temperature can be viewed in
the “Test Pool Pilot” menu for diagnostic purposes.
7.6.8 Set 12/24 Hour Clock (Optional Feature w/ 863A Expansion Board)
Set personal preference for time clock display.
1) Press MENU, press or until “Owner options” or “Installer Menu” is
displayed, then press SELECT.
2) Press or until “12/24 hour clock” is displayed, then press SELECT (12 hour is
the factory setting).
3) Press or until desired time format “12 hour” or “24 hour” is displayed, then
press SELECT.
4) Press or until “End menu mode” is displayed then press SELECT.