Autostacker™ Parking Lift 34 P/N 5900248 — Rev. B — May 2021
Add the Tire Trough and Tire Stops
The Tire Trough is a lowered section of the Platform that holds the tires of the Vehicle. The Tire Stops
attach to the top of the Tire Trough and add a bit of extra height for holding Vehicles with larger tires.
Important: The forward wheels of the Vehicle on the Platform must
always
be sitting fully in the
Tire Trough.
⚠ WARNING The Tire Trough is heavy. Move it into position using a lifting device such as a
Forklift or Shop Crane. If this is not an option, have at least two people to move it.
Do not allow just one person to move the Tire Trough
; they could be
injured.
The Tire Stops attach to the
top of the Top Trough,
functioning as a Tire Chock.
Not to scale.
To install the Tire Trough and Tire Stops:
1. Move the Tire Trough into position next to the Top Connector Tube.
A section of the Tire Trough rests on the Top Connector Tube. This is where the Tire Stops go and
where you attach the Tire Trough to the Top Connector Tube.
2. Get the necessary Bolts (4), Nuts (4), and Washers (8) from the Parts Bag.
3. Put the Tire Stops on top of the Tire Trough; align the holes in the bottom of the Tire Stops with
the holes in the Tire Trough and the Top Connector Tube.
4. Orient the Tire Stops so that the vertical portion is on the Tire Trough side, then secure the Tire
Trough and Tire Stops in place, as shown below.
Drawing shows how to
connect the Tire Stops and
Tire Trough in place.
Not all components are
shown.
5. Repeat Steps 4 and 5 for each of the other holes.
To Next Page
Loading...