Autostacker™ Parking Lift 47 P/N 5900248 — Rev. B — May 2021
To install an Access Panel:
1. If you have already installed the Platform sections, remove them.
2. Put the Access Panel in the general location where you want it.
3. Starting next to the Tire Trough, put a Platform section next to the Tire Trough and then slide the
end closest to the Tire Trough under it slightly.
4. Keep adding Platform sections the same way until you get to the Access Panel.
5. Move the Access Panel next to the last Platform section you added, then slide the end closest to
the Platform section under it slightly.
6. Add the remaining Platform sections.
Each Access Panel takes the place of three Platform sections.
7. When the last Platform section is in place, move the Drive-Up Ramp into place.
The end of the last Platform section and the top of the Drive-Up Ramp
must
overlap.
⚠ WARNING The Drive-Up Ramp is heavy. You should move it into position using a lifting device
such as a Forklift or Shop Crane. If this is not an option, use at least two people to
move it.
Do not allow just one person to move the Drive-Up Ramp
; they
could be injured.
8. Check to make sure all of the Platform pieces and the Drive-Up Ramp are correctly positioned.
To Next Page
Loading...