Need help?Do you have a question about the Autotek ATX1000.2 and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| Power Output (RMS) | 1000W |
| RMS Power @ 4 Ohms | 250W x 2 |
| RMS Power @ 2 Ohms | 500W x 2 |
| Bridged RMS Power @ 4 Ohms | 1000W x 1 |
| Total RMS Power Output | 1000W |
| THD | <0.05% |
| Signal to Noise Ratio | >95dB |
| Input Sensitivity | 200mV-6V |
| Minimum Impedance Unbridged | 2 Ohms |
| Minimum Impedance Bridged | 4 Ohms |
| Bass Boost | 0-12dB |
| Input Voltage | 14.4V |
| THD at Rated Power | <0.05% |
Guidelines for selecting and connecting power and ground cables.
Step-by-step process for safely powering on the system.
Setting up a 2-way active or bi-amplified system with 2-channel amps.
Comprehensive setup for High Pass, Bass EQ, Low Pass, and Level controls.
Specific setup for Subsonic, Bass EQ, Low Pass, and Level for ATX2000.1.
Explains amplifier protect mode and heatsink overheating.
Diagnoses common problems like no power, blown fuses, and noise.
To Next Page
