Need help?Do you have a question about the Autotek M1000.4 and is the answer not in the manual?
Discusses the importance of system design for car stereo success and amplifier performance.
Provides guidance on mounting amplifiers horizontally for optimal heat dissipation and avoiding noise.
Advice on routing RCA cables away from power cables and electrical noise sources.
Details on selecting proper gauge cables and ensuring solid electrical connections for power and ground.
Step-by-step guide for connecting speaker, power, ground, and remote turn-on leads safely.
A recommended safe procedure for turning on the system for the first time to avoid issues.
Highlights key capabilities like stereo/mono operation, input sensitivity, and crossover filters.
Details specific features and control functions for 2-channel amplifier models.
Explains features and controls for 4-channel amplifier models, including multi-channel operation.
Describes features and controls specific to the mono block amplifier series.
Illustrates the basic connection for full-range stereo operation using 2-channel amplifiers.
Shows how to connect amplifiers in mono bridging mode for increased power output.
Demonstrates how to use 4-channel amplifiers for a discrete 4-channel full-range system.
Explains setting up a 3-channel system using mono bridging on a 4-channel amplifier.
Configuration for a system using a 4-channel amp for front/rear highs and a 2-channel for mono sub.
Illustrates the basic setup for mono sub bass amplifiers, including wiring and impedance.
Guidance on setting High Pass, Bass EQ, Low Pass, and Level controls for multi-channel amps.
Guidance on setting Subsonic, Bass EQ, Low Pass, and Level controls for mono amps.
Explains the amplifier's diagnostic system, PROTECT LED, and fault indicators.
Details reasons for amplifier overheating and methods to improve cooling and airflow.
Troubleshooting steps for issues related to low output power from the amplifier.
Identifies common reasons for amplifier fuses blowing, including impedance and shorts.
Steps to diagnose why the audio system or amplifier is not powering on.
Addresses hiss, electrical interference, and engine-related noises in the audio system.
Converts high-level speaker signals to RCA low-level outputs with parametric EQ and clipping indicators.
An accessory for subwoofer output shaping, offering bass boost, bandwidth, and low-pass filters.
Converts OEM speaker wire signals to RCA low-level outputs, featuring audio signal sense turn-on.
Converts high-level OEM speaker wires to RCA low-level outputs for adding a subwoofer.
General| Channels | 4 |
|---|---|
| Power Output (RMS) | 1000W |
| Power Output (Peak) | 2000W |
| RMS Power @ 4 Ohms | 125W x 4 |
| RMS Power @ 2 Ohms | 250W x 4 |
| Bridged RMS Power @ 4 Ohms | 500W x 2 |
| Total RMS Power Output | 1000W |
| Input Sensitivity | 200mV - 6V |
| Crossover Slope | 12dB/Octave |
| Fuse Rating | 40A x 2 |
To Next Page
