Need help?Do you have a question about the Autotek M1600.2 and is the answer not in the manual?
Discusses system design principles for car audio installations.
Covers physical mounting, wiring practices, and electrical noise prevention.
Details power and ground cable gauge and connection requirements for amplifiers.
Outlines the recommended order for connecting cables and safely powering the system.
Lists general features common to the Mean Machine series amplifiers.
Details controls and functions specific to 2-channel models.
Explains features and operation of 4-channel amplifiers.
Describes features and capabilities of mono block amplifiers.
Shows the basic setup for full range stereo operation with 2-channel amps.
Illustrates the basic mono bridging method for 2-channel amplifiers.
Demonstrates setting up a discrete 4-channel full range system.
Explains configuring a 3-channel system using mono bridging.
Shows combining amps for front/rear highs and mono sub bass.
Details the basic setup for mono sub bass amplifiers.
Shows how to wire multiple subwoofers in parallel to mono amps.
Provides detailed setup guidance for multi-channel amplifiers.
Offers specific setup instructions for mono block amplifiers.
Explains the amplifier's diagnostic system and PROTECT LED.
Details causes and solutions for overheating and low output power.
Guides on troubleshooting blown fuses and no power.
Covers common noise issues like hiss and electrical interference.
Outlines the limited warranty terms and conditions for Autotek amplifiers.
General| Channels | 2 |
|---|---|
| Total Harmonic Distortion (THD) | <0.05% |
| Signal-to-Noise Ratio | >95dB |
| Minimum Impedance Unbridged | 2 Ohms |
| Minimum Impedance Bridged | 4 Ohms |
| Bass Boost Frequency | 45Hz |
| Input Sensitivity | 200mV-6V |
| Low Pass Filter | Yes |
| High Pass Filter | Yes |
| Low Pass Crossover Frequency | 250Hz |
| Bass Boost | 0-12dB |
To Next Page
