Need help?Do you have a question about the Autotek M1400.4 and is the answer not in the manual?
General| Brand | Autotek |
|---|---|
| Model | M1400.4 |
| Category | Car Amplifier |
| Language | English |
Details on optional accessories like crossovers and EQ/line drivers for enhancing audio systems.
Guidance on system design, including amplifier mounting and importance of quality components for optimal performance.
Instructions for proper power and ground wiring, including wire gauge recommendations and connection integrity.
Step-by-step guide for connecting audio components safely, starting with signal cables and ending with power connections.
Procedure for safely powering on a new audio system, including fuse installation and initial checks.
Overview of general features and capabilities of Mean Machine amplifiers, including diagnostic systems.
Detailed description of the features and controls for the 2-channel Mean Machine amplifiers.
Detailed description of the features and controls for the 4-channel Mean Machine amplifiers.
Detailed description of the features and controls for the mono block Mean Machine amplifiers.
Basic stereo application setup for the 2-channel Mean Machine amplifiers.
Illustrates the basic mono bridging method for the 2-channel Mean Machine amplifiers.
Guide for using 4-channel amplifiers as discrete full-range units.
Guide for using 4-channel amplifiers in a 3-channel configuration via mono bridging.
Setting up a system with a 2 and 4-channel amplifier for front/rear highs and mono sub bass.
Instructions for using mono amplifiers in bi-amplification systems and connecting multiple subwoofers.
Guidance on setting High Pass, Bass EQ, Low Pass, and Level Controls for multi-channel amps.
Guidance on setting Subsonic, Bass EQ, Low Pass, and Level Controls for mono amplifiers.
Explanation of the amplifier's diagnostic system and indicators for faults like short circuits or DC offset.
Causes and solutions for amplifier heatsink overheating, related to cooling and impedance.
Steps to diagnose and resolve issues with low output power from the amplifier.
Common reasons for amplifier fuses blowing, including impedance issues and shorts.
Troubleshooting steps for when the audio system fails to power on.
Diagnosing and resolving hiss, electrical interference, and other noise issues in the audio system.
Converts high-level speaker signals to low-level RCA outputs, featuring parametric EQ and clipping indicators.
Converts high-level speaker wires to clean RCA low-level outputs, with audio signal sense and remote output.
Controls subwoofer output signal shaping, including bass boost, bandwidth, low pass, and subsonic filters.
Converts high-level signals to low-level RCA outputs for adding a subwoofer, with audio signal sense.
To Next Page
