Need help?Do you have a question about the Autotek M2500.1D and is the answer not in the manual?
Covers system design for car audio, emphasizing setup and component matching for optimal performance.
Details physical mounting, cable routing, and electrical connections for amplifiers, ensuring proper installation and safety.
Explains correct gauge wiring and connection methods for power and ground leads, crucial for amplifier operation and safety.
Provides a step-by-step procedure for connecting and powering up the audio system to avoid damage and ensure correct operation.
Details features, controls, and operation modes for the M1600.2 and M3200.2 2-channel amplifiers.
Explains functionality and settings for M1000.4, M1400.4, M2000.4 4-channel amps, including multi-channel operation.
Covers features and specifications for M1500.1D, M2500.1D, M4000.1D mono block amplifiers, including impedance capabilities.
Illustrates the basic full range stereo setup for the 2-channel Mean Machine amplifiers.
Shows the mono bridging method for 2-channel amplifiers, suitable for subwoofers or high-power mono output.
Demonstrates using 4-channel amplifiers as discrete units for a full-range stereo system.
Explains how to use 4-channel amplifiers in 2 or 3 channel configurations via mono bridging.
Details using 4-channel amps with a 2-channel amp for front/rear highs and mono sub bass.
Shows the basic application for mono amplifiers, including wiring for single or multiple subwoofers.
Guides on adjusting High Pass and Low Pass filters for optimal frequency cutoff in multi-channel systems.
Explains how to set Bass EQ for desired impact and adjust Level controls for proper input sensitivity matching.
Details setting the Subsonic filter for mono amps and adjusting Level controls for input sensitivity.
Provides guidance on balancing levels for 2 or 3-way active systems for cohesive sound reproduction.
Explains the amplifier's diagnostic system, indicated by the PROTECT LED, for detecting faults like short circuits or DC offset.
Identifies common causes for amplifier overheating and suggests solutions for adequate cooling and proper impedance usage.
Provides steps to diagnose and resolve issues related to low output power, checking level controls, voltage, and connections.
Lists reasons for fuse blowing, including impedance issues, shorts, or faulty amplifier components.
Guides on diagnosing why the system does not turn on, checking fuses, connections, and voltage at various points.
Covers common noise problems like hiss and electrical interference, offering methods to isolate and eliminate them.
Outlines the one-year limited warranty for amplifiers and accessories, including coverage and exclusions.
Details the MX-1, a premium high-to-low level converter with parametric EQ and clipping indicators.
Describes the MX-3 bass controller, offering subwoofer output shaping, clipping indicators, and bass remote functionality.
Explains the MX-2, a deluxe high-to-low level converter with audio signal sense and remote output.
Covers the MX-4, a high-to-low level converter designed for adding subwoofers, with audio signal sense.
Details the Maxx-Link MLX-100's ability to link or strap mono amps, controlling multiple amplifiers with one pre-amp.
General| Channels | 1 |
|---|---|
| RMS Power at 2 Ohms | 1250W |
| RMS Power at 1 Ohm | 2500W |
| Signal to Noise Ratio | >95dB |
| Input Sensitivity | 200mV - 6V |
| Subsonic Filter | 10Hz - 50Hz |
| Low Pass Filter | 35Hz - 250Hz |
| Fuse Rating | 250A |
| Damping Factor | 200 |
| Bass Boost | 0dB - 12dB @ 45Hz |
To Next Page
