Need help?Do you have a question about the Autotek M2000.4 and is the answer not in the manual?
Discusses factors for successful car stereo system design.
Guidelines for physically mounting amplifiers and ensuring proper airflow.
Covers wire routing, power/ground connections, and safe wiring.
Outlines safe connection steps and system power-up procedures.
General features and capabilities of the Mean Machine amplifier series.
Details features and controls for M1600.2 and M3200.2 amplifiers.
Explains features and controls for M1000.4, M1400.4, and M2000.4 amplifiers.
Describes features and controls for M1500.1D, M2500.1D, and M4000.1D amplifiers.
Basic setup for full range stereo operation using 2-channel amplifiers.
Guide for mono bridging setup with 2-channel amplifiers.
Setup for using 4-channel amps as discrete full range units.
Configuring 4-channel amps for 2 or 3-channel operation via bridging.
System setup using 4-channel and 2-channel amps for front/rear highs and mono sub.
Standard setup for mono amplifiers with a single subwoofer.
Instructions for wiring multiple subwoofers in parallel to mono amps.
Configuring the high pass filter for optimal frequency response.
Adjusting bass boost and low pass filters for desired sound.
Matching amplifier input sensitivity to the head unit output.
Balancing levels for 2 or 3-way active system configurations.
Diagnosing protect mode, DC offset, and internal amplifier faults.
Addressing amplifier overheating, low output power, and fuse problems.
Troubleshooting no power, hiss, electrical interference, and engine-related noises.
Converts speaker wire to RCA outputs with features like parametric EQ.
Controls bass response, includes parametric EQ and clipping indicators.
Converts OEM speaker wires to RCA outputs, with audio signal sense.
General| Channels | 4 |
|---|---|
| THD at RMS Output | <0.05% |
| Signal to Noise Ratio | >95dB |
| Input Sensitivity | 200mV-6V |
| Crossover Slope | 12dB |
| Crossover | Variable Low-Pass |
To Next Page
