AUTOTERM PU-27 - Pump Type Selection; Alarm Channel Control; Reset Settings to Default

11
Power value
Heater power value in the 0 to 9 range, where 0 is minimum and 9
is maximum power.
T setpoin
The value at which the heater will switch to standby mode. The
heater will switch from standby mode when the temperature of the
sensor used to control heater operation drops 5 °C below the “Set
temperature” value.
Ventilation
Ventilation mode ON setting
-
Ventilation mode OFF. When the heater switches to standby
mode, the air pump will shut off.

Ventilation mode ON. When the heater switches to standby
mode, the air pump will continue to operate in ventilation
mode.
Action of Settings menu keys:
Keys
Action
Navigation through the menu items
Exit from this menu to the main screen
Change menu item value
Parameters settings menu
This menu is intended for setting control panel
parameters.
Parameters menu items:
Fading
Setting of indicator lighting time.
By default, the control panel indicator lighting time is 30
seconds. The light duration can be set in the 10 to 120 sec.
range with a 1 sec. step, or to set continuous lighting; in the
latter case, the “-“ sign will appear on the display.