AUX DC Inverter Free Match 50HZ R32
131
In the timing setting zone: HH means series NO. MM means parameter value. After entering into
IDU parameter checking , via pressing the“ ”or“ ”button ,you can check the parameter value
of series NO.【04】【05】【1】.
Parameter setting
Only in parameter checking model, press the “FUNCTION” button for 5 seconds,
Enter into parameter setting model.
The corresponding parameter valve “MM” began to flash, changing it through pressing
the“ ”or“ ”burton, after finished ,press the “FUNCTION” button to confirm. When finishing
parameter setting, it will automatically go back to parameter checking model.
1. Press “FUNCTION” for 5S, enter parameter checking
2. Press “ ”or“ , change the parameter value
of seires NO.
HH: means seires NO.
MM: means parameter value.
To Next Page
Loading...
Need help?
General
