8
1. Make sure the printer's power switch is in
the OFF position.
2. Insert the AC power cord into the power supply.
3. Insert the power supply's power connector into
the printer's power jack.
4. Plug the other end of the power cord into an
appropriate grounded AC electrical outlet.
1. Open top cover of the printer.
2. Put the Media Hanger through
Media Supply Roll, then
centrally align with the (2)
Media Shields so they lean
against the roll.
3. Place the Media Supply Roll
into the Media Compartment
of the printer.
4. Push the Release Levers to
open the Printer Module.
5. Pull a short length of media
until it reaches the Platen Roll
of the printer. Adjust the Media
Guide on the right so the roll is
left-aligned.
6. Close the Printer Module,
then press both sides firmly
until you hear a click.
In case the paper roll becomes dirty during shipment, handling, or storage, begin by removing the
outside length of media, which helps prevent dirt from coming in contact with the print head and
platen roller. Load the media by placing onto the media hangers.
POWERING ON
LOADING MEDIA
• Do not operate the printer and power supply
in an area where they might get wet.
Media Roll
Media Hanger
Release Levers
Media
Compartment
To Next Page
Loading...
Need help?
General