What to do if the display shows E06 high pressure protection on Avantco 194MCF530A?
If your Avantco Ice Maker displays an E06 error, indicating high pressure protection, check the fan and correct it if it doesn't start. Also, check and correct the high pressure switch wires.
Why is the ice defrost abnormal in my Avantco 194MCF530A Ice Maker?
Abnormal ice defrost in your Avantco Ice Maker can be due to several reasons: * The ambient temperature might be too low; the normal working temperature range is 41-95°F. * The defrost valve may not be starting normally; check and correct the defrosting valve. * The ice thickness might be set too thin or too thick; check and correct the ice thickness setting.
What to do if Avantco 194MCF530A Ice Maker display shows E04 high temperature?
If your Avantco Ice Maker displays an E04 error, indicating high temperature, the condenser may be dirty. Clean the condenser.
Why does my Avantco 194MCF530A shut down every 3 minutes after startup?
If your Avantco Ice Maker shuts down every 3 minutes after startup, the ambient temperature may be too high. The normal working temperature range is 41-95°F.
What to do if indicator is OFF on Avantco 194MCF530A?
If the indicator is off on your Avantco Ice Maker, check the plug and socket to ensure they are properly connected.
What to do if my Avantco 194MCF530A Ice Maker shows E06 high pressure protection?
If your Avantco Ice Maker displays the error code E06 indicating high pressure protection, it could be due to the fan not starting. Verify the fan and correct any issues. Also, check the high pressure switch wires and correct if necessary.
Why is ice defrost abnormal in my Avantco 194MCF530A Ice Maker?
If your Avantco Ice Maker's ice defrost is abnormal, it might be due to several reasons. The ambient temperature could be too low; ensure it's within the normal working range of 41-95°F. Also, the defrost valve may not be starting normally, so check and correct the defrosting valve. Finally, the ice thickness might be set incorrectly; check and correct the ice thickness setting.
Why does my Avantco 194MCF530A Ice Maker shutdown every 3 minutes?
If your Avantco Ice Maker shuts down every 3 minutes after startup, it could be because the ambient temperature is too high. The normal working temperature range is 41-95°F.
Safety warnings for fire, explosion, and refrigerant handling.
Guidelines for product use, installation environment, and handling.
Installation location requirements: temperature, power, and water.
Step-by-step guide for ice machine installation and connections.
Confirmation checks for correct ice machine operation.
Startup, self-check, ice making, harvesting, and shutdown procedures.
Common ice machine faults, potential causes, and troubleshooting.
Final checks and initial startup procedures for the dispenser.
Ice dispenser symptoms, causes, and fixes for troubleshooting.
Warranty coverage for parts and labor for one year.
Extended warranty coverage for the compressor component.
General| Model | 194MCF530A |
|---|---|
| Refrigerant | R404A |
| Hertz | 60 |
| Phase | 1 |
| Voltage | 115 |
| Refrigerant Type | R404A |
| NSF Listed | Yes |
| Energy Star Qualified | No |
| Production Capacity | 530 lbs per day |
| Power Supply | 115V |
| Condenser Type | Air Cooled |
To Next Page