What to do if the display shows E06 high pressure protection on Avantco Ice Maker?
If your Avantco Ice Maker displays an E06 error, indicating high pressure protection, check the fan and correct it if it doesn't start. Also, check and correct the high pressure switch wires.
Why is the ice defrost abnormal in my Avantco 194MCH530A Ice Maker?
Abnormal ice defrost in your Avantco Ice Maker can be due to several reasons: * The ambient temperature might be too low; the normal working temperature range is 41-95°F. * The defrost valve may not be starting normally; check and correct the defrosting valve. * The ice thickness might be set too thin or too thick; check and correct the ice thickness setting.
What to do if Avantco Ice Maker display shows E04 high temperature?
If your Avantco Ice Maker displays an E04 error, indicating high temperature, the condenser may be dirty. Clean the condenser.
Why does my Avantco 194MCH530A Ice Maker shut down every 3 minutes after startup?
If your Avantco Ice Maker shuts down every 3 minutes after startup, the ambient temperature may be too high. The normal working temperature range is 41-95°F.
What to do if indicator is OFF on Avantco Ice Maker?
If the indicator is off on your Avantco Ice Maker, check the plug and socket to ensure they are properly connected.
What to do if my Avantco 194MCH530A Ice Maker shows E06 high pressure protection?
If your Avantco Ice Maker displays the error code E06 indicating high pressure protection, it could be due to the fan not starting. Verify the fan and correct any issues. Also, check the high pressure switch wires and correct if necessary.
Why is ice defrost abnormal in my Avantco Ice Maker?
If your Avantco Ice Maker's ice defrost is abnormal, it might be due to several reasons. The ambient temperature could be too low; ensure it's within the normal working range of 41-95°F. Also, the defrost valve may not be starting normally, so check and correct the defrosting valve. Finally, the ice thickness might be set incorrectly; check and correct the ice thickness setting.
Why does my Avantco Ice Maker shutdown every 3 minutes?
If your Avantco Ice Maker shuts down every 3 minutes after startup, it could be because the ambient temperature is too high. The normal working temperature range is 41-95°F.
Conditions required for proper ice machine installation.
Step-by-step guide for setting up the ice machine.
Detailed steps for operating the ice machine after setup.
Table listing common faults, potential causes, and troubleshooting steps.
Details on connecting the drain fitting for the dispenser.
Steps for electrical connection and assembling the ice machine with the dispenser.
Final checks, initial startup procedures, and operator training.
Table of symptoms, probable causes, and possible fixes for dispenser issues.
General| Model | 194MCH530A |
|---|---|
| Production Capacity | 530 lbs per day |
| Refrigerant | R404A |
| Voltage | 115V |
| Type | Ice Maker |
| Power Supply | 115V/60Hz |
| Features | Digital Controls |
| Installation Type | Modular |
| Width | 24" |
| Water Connection | 3/8" |
To Next Page