Avaya 4900 Series - Console Port Pin Assignments; Equipment Requirement; Verifying the Package Contents

Console port pin assignments
The following table describes the console port pin assignments.
Table 8: RJ–45 Console port pin assignments
Connector Pin Number Signal
1 Ready to send (RTS) — optional
2 Data terminal ready (DTR) — optional, can swap or link with pin
8
3 Transmit data (TXD) — mandatory
4 Carrier detect (DCD) — optional
5 Ground (GND) — mandatory
6 Receive data (RXD) — mandatory
7 Data set ready (DSR) — optional
8 Clear to send (CTS) — optional, can swap or link with pin 1
Equipment requirement
After unpacking this switch, check the contents to be that sure you have received all the
components. Then, before beginning the installation, be sure that you have all other necessary
installation equipment.
Verifying the package contents
For each Ethernet Routing Switch 4900 Series, verify the package contents with the items in the
following figure to ensure you have received all components. If any components are missing,
contact the vendor where you purchased the switch.
Installing Ethernet Routing Switch 4900 Series
February 2016 Installing Avaya Ethernet Routing Switch 4900 Series 22
Comments on this document? infodev@avaya.com