Figure 7: Rear-mounted rack bracket installation
Installing optional four-post rack-mount brackets
Perform this procedure to assemble and install the four-post rack-mount bracket kit.
Before you begin
Ensure to check for the following:
• Four-post server rack-mount kit.
• Verify that you have all the screws and brackets to assemble and install the four-post rack
mount kit.
• Tools:
- Phillips screwdriver to attach brackets to the switch and the switch to the rack.
- Hex wrench to assemble and attach the optional four-post rack-mount brackets.
• Rack requirements:
- Space of 2.8 inches (7.1 centimeters) for each switch in an E1A or 1EC standard 19 inch
(48.2 centimeter) equipment rack and T1A 23 inch (58.5 centimeter) equipment rack.
Installing Ethernet Routing Switch 4900 Series
February 2016 Installing Avaya Ethernet Routing Switch 4900 Series 30
Comments on this document? infodev@avaya.com
To Next Page
Loading...
