connector of the last unit physically at the top of the stack. The stack is wired upward through the
units and the system continues to number in this manner throughout the stack. In this configuration,
the base unit discovers the stack in a cascade up (stack up) direction.
1. Base Unit
2. Last Unit
3. Cascade or Stack Cable
4. Cascade/Stack Cable (Return cable to make stack resilient. Use longer
Stack Cable if required)
Figure 13: Cascade Up (Stack Up) configuration
Installing Ethernet Routing Switch 4900 Series
February 2016 Installing Avaya Ethernet Routing Switch 4900 Series 48
Comments on this document? infodev@avaya.com
To Next Page
Loading...
