Avaya Inc. – Proprietary & Confidential.
Use pursuant to the terms of your signed agreement or Avaya policy.
50
Ethernet Routing Switch 8600
Software Release 5.1.1.0
SoftwareRelease5.1.1.0
1.ReleaseSummary
Release Date: 7 August 2009
Purpose: Software maintenance release to address software issues found both in the field and internally.
2.ImportantNotesbeforeUpgradingtoThisRelease
If upgrading to 5.1.1.0 code within any SMLT designed network from a release prior to 4.1.8.2 or 5.0.1.0, i.e. a
release which runs the ‘older’ SMLT architecture, then care should be taken to follow the proper upgrade steps.
Please review the 4.1.8.2 Readme or 5.0.1.0 RN for specific details.
REGARDLESS OF SOFTWARE VERSION
, the system-monitor flag should be checked on all systems to be
sure it is enabled. This flag should always be enabled. The flag setting can be checked via the command,
show config. The display should be something like:
ERS8600:6#showconfig
PreparingtoDisplayConfiguration...
#!flagsm‐modefalse
#!flagsenhanced‐operational‐modefalse
#!flagsvlan‐optimization‐modefalse
#!flagsglobal‐filter‐orderingfalse
#!flagsr‐modetrue
#!resource‐reservationmax‐vlanfalse
#!resource‐reservationmulticast2048
#!flagsmulticast‐check‐packettrue
#!flagssystem‐monitortrue(enabled) or
potentialfalse(disabled)
#!flagsregular‐Autonegfalse
#!record‐reservationfilter4096
If the system-monitor flag is set false, then it should be changed to true (requires a reboot to take affect), which
can only be accomplished by either JDM, Edit Chassis -> System Flags and then look under “System
Monitoring” at the bottom of the screen. Checked equals enabled. To set via SNMP use:
MIBisrapidCity.rcMgmt.rcChassis.rcChasSystemMonitorEnable
snmpget -v 1 -c public x.x.x.x enterprises.2272.1.4.41.0
Output is either:
To Next Page
Loading...
