Avaya Inc. – Proprietary & Confidential.
Use pursuant to the terms of your signed agreement or Avaya policy.
60
Multicast Routing Protocol
PIM
ERS 8600 will now properly forward packets to the DR when the egress port to the
DR is the same as the incoming port and the port to the DR changes for some
reason. (Q01907611-04)
9.OutstandingIssues
Please refer to the Outstanding Issues Section of the Release Notes for Ethernet Routing Switch 8600
Software Release 5.1.0.0. Additionally, the following issues will be fixed in a future release.
Platform
The change for CR 1767930 which is related to proper operation of SCP (Secure
Copy) while using Access Policies, which was fix in the 4.1.x stream back in
4.1.6.3, is missing from all 5.x streams. This will be resolved in all future 5.x code
streams, but is still missing in 5.1.1.0.
Configuration
While configuring ds-field under “config ip traffic-filter filter <filter-id> match”, if we
give the six dscp bits, it is taking the command improperly. (Q02056382)
MLT
An MLT with LACP enabled along with min-link configured, may not have ports
added to the MLT properly. (Q02034692)
STATIC ROUTE
When a static route is created within the non-default VRF, it may not become active
and high number of such static routes may lead to increased CPU utilization. For
system running with only the default VRF (VRF 0) this is of no concern. For those
running with multiple VRFs, use of static routes in the non-default VRF (outside of
VRF 0) should be limited or not used at all; instead use some routing protocol, such
as OSPF or RIP. (Q02060978)
To Next Page
Loading...
