Avaya Inc. – Proprietary & Confidential.
Use pursuant to the terms of your signed agreement or Avaya policy.
61
10.KnownLimitations
Please refer to the Known Limitations Section of the Release Notes for Ethernet Routing Switch 8600
Software Release 5.1.0.0. Additionally, the following issues have also been classified as operation not
to be changed.
Switch management
"Secret" is no longer the default SNMP community string for read/write access. Instead
there is none and it needs to be configured via CLI before SNMP can be used. This
has been the operation for some time now, not just introduced with 5.1.1.0 code.
(Q02049550)
Clients may loose connectivity when filters are applied on tagged ports, with default port
action of drop. Such a configuration is not supported. Instead use filter configuration of
default port action of forward and drop filters. (Q01906338-02)
SNMP-generated traps are not being processed by the MDM Carrier Management
station, due to a checksum error in the UDP packets. This situation will NOT be seen if
the source IP used in the SNMP Sender-IP parameter is some Circuitless IP address.
(Q02047909)
11.DocumentationCorrections
Dual MLTs in SMLT designs are supported, as long as only one is configured as an IST_MLT (system
will not allow mis-configuration), and as long as any use of any form of spanning tree and the
VLANs/ports associated with this form of spanning tree, remain solely on the non-IST_MLT; there can
be no association or interaction with the IST_MLT. (Q02047748)
The command config sys set snmp-ip no longer will accept an IP address of value 0.0.0.0, which would
be illegal to start with. (Q02062013)
Copyright © 2009 Nortel Networks Limited - All Rights Reserved. Nortel, Nortel Networks, the Nortel logo, Globe mark, and Ethernet
Routing Switch 8100/8300/8600 are trademarks of Nortel Networks Limited.
The information in this document is subject to change without notice. The statements, configurations, technical data, and recommendations
in this document are believed to be accurate and reliable, but are presented without express or implied warranty. Users must take full
responsibility for their applications of any products specified in this document. The information in this document is proprietary to Nortel.
To access more technical documentation, search our knowledge base, or open a service request online, please visit Nortel Technical
Support on the web at: http://www.nortel.com/support
To Previous Page
Loading...
