Job Aid
July 2003
11
555-245-768, Issue 1
Comcode 700281124
Replace the Hard-drive
!
CAUTION:
Wear an antistatic wrist ground strap whenever handling components such as the hard drive of an Avaya
S8700 Media Server. Connect the strap to an approved ground, such as an unpainted metal surface.
Also, place the hard drive on an antistatic mat that is similarly grounded. Do not place the new or the old
drive on a bare surface.
Remove the Cover of the S8700 Media Server
1. Set the media server down on a flat surface with an electrostatic mat.
2. With your hex-head wrench, remove the 4 screws (‘‘Media Server Cover Removal and Replacement’’ on
page 12) that hold the brackets on to the side of the media server. Removing these screws also allows you to
release the media server cover on the sides.
3. Use a #1 cross-point (Phillips) screwdriver to unscrew the two screws at the back of the media server that
hold the cover in place (‘‘Media Server Cover Removal and Replacement’’ on page 12).
4. Slide the media server cover back from the front panel (‘‘Media Server Cover Removal and Replacement’’ on
page 12) until the cover’s tabs are released from the top slot of the front panel.
5. Lift the cover straight up and remove it from the media server.
To Next Page
Loading...
