the XT Series and its XT Remote Control Unit to pair them. By default all remotes and endpoints1
use the same code 01.2
Procedure3
1. Access the general settings. From the XT Series web interface, select Basic Settings >4
General. From the endpoint's main menu, select Configure > General.5
You can use the XT Remote Control Unit's initial default pairing to perform this task.6
7
Figure 12: Setting the XT Remote Control Unit Code8
2. Enter a two-digit numeric code between 01 and 96 in the Remote Control Code field.9
3. From the web interface only, select Save.10
4. On the Simplified XT Remote Control Unit, press the * and # keys simultaneously until its11
RED light blinks twice. On the advanced remote control unit, press the RED and GREEN12
keys simultaneously until the GREEN light becomes RED.13
14
Figure 13: Setting the code on the XT Remote Control Unit15
Controlling the XT Series
December 2017 Avaya Scopia
®
XT Series User Guide 27
Avaya - Proprietary. Use pursuant to the terms of your signed agreement or Avaya policy.
DRAFT—December 15, 2017—1:33 PM (UTC)
To Next Page
Loading...
