Avaya T7316E - Ringer Volume

T7316E Telephone User Guide Page 64
- Issue 02a (03 October 2011)IP Office
11. Phone Settings
11.1 Contrast
You can change the contrast on the phone display.
1.
Press Feature *7.
2.
Use the number keys to select the required contrast. Alternatively, use the and buttons to change the
contrast.
3.
The function will automatically cancel after a 3 seconds.
11.2 Ringer Sound
You can change the ringer sound. This does not change the ring pattern which is controlled by the telephone system.
1.
Press Feature *6.
2.
Press 1 to 4 to select the required ringer sound.
· Whilst the function is active, you can also use the and buttons to change the ringer volume.
3.
The function will automatically cancel after a 5 seconds.
11.3 Ringer Volume
You can change the ringer volume using the following process. You can also adjust the volume while a call is ringing your
phone.
1.
Press Feature *80. The phone will start a continuous ring.
2.
Use the soft and loud volume buttons to change the volume to the level required.
3.
The function will automatically cancel after a 5 seconds.
11.4 Enbloc Pre-Dialing
You can enable or disable your enbloc pre-dialing using Feature 82. When on, you can compose a number to dial
without the digits being dialed until the number is complete.
· This function can be assigned to a programmable button . This allows it to be accessed in a single key press. If
the button includes an indicator, it will indicate the status of the function (on or off).
1.
Press Feature *82.
2.
The phone displays Enbloc dial and the current setting.
3.
Press the on or off soft key to change the setting.
20
69