Unified Communications Module Installation and Maintenance Page 96
15-601011 Issue 03l (28 August 2012)IP Office
8.3.3 Configuration Commands
The Configure> prompt is accessed by entering configure at the Admin> prompt and then entering the configurator
password (the default password is Configurator).
In the commands below, <application> is replaced with name of the required application: voicemail, onexportal,
watchdog or all.
At the Configure> prompt, the following commands can be used:
· autostart <application> <on/off>
Change the autostart settings of an application.
· backup <application>
Backup the application. This command is currently only supported for the onexportal application.
· exit
Exit the Configure> prompt and return to the Admin> command prompt.
· help
Display general help on entering commands.
· history
Display the history of commands used in the current session.
· list
Display a list of commands.
· logout
End the session and logout.
· password
Change the configuration password required to access the Configure> prompt.
· install <application>
Install an application from the repository.
· repository <type> <link>
Set the location for the updates repository.
· The <type> value indicates the repository:
· os
Operating system repository.
· services
Applications repository.
· The <link> value indicates the repository location.
· restore <application>
Restore an application. This command is currently only supported for the onexportal application.
· search
Search for an application and display basic information if found on the server.
· show
Display a list of installed applications.
· startup <application> <on/off>
Set the start on boot up setting for an application.
· uninstall <application>
Uninstall an application.
· top
Return to the > prompt.
95
95
93
To Next Page
Loading...
