Installation fundamentals
The VSP 7200 Series has two models: VSP 7254XSQ (fiber) and VSP 7254XTQ (copper). The VSP
7254XSQ consists of forty eight 1/10 GbE SFP/SFP+ ports. The VSP 7254XTQ consists of forty
eight 100 Mbps/1 GbE/10 GbE RJ-45 ports.
Both models include the following features:
• six 40 GbE QSFP+ ports
• one USB port
• Base Software License
• one field-replaceable power supply (either AC or DC)
• three field-replaceable 12 volt fan modules
Figure 1: VSP 7200 — Front view
1. LEDs indicating port activity are above the RJ-45 and SFP+ port. The up arrow on the left indicates the
top port; the down arrow on the right indicates the bottom port. For a description of what the LEDs mean,
see RJ-45 copper port LEDs on page 37 or SFP port LEDs on page 38.
2. 48 ports — The VSP 7254XSQ has 48 SFP/SFP+ fiber ports. The VSP 7254XTQ has 48 RJ-45 copper
ports.
3. Six QSFP+ ports — The LEDs are below each port. There are four LEDs per port to support
channelization. The up arrows refer to the port above. For a description of what the LEDs mean, see QSFP+
port LEDs on page 38.
4. USB port
5. LEDs for system power (PWR), switch status (Status), redundant power supply (RPS), and fan modules
(Fan). For more information, see Switch LEDs on page 36.
The following figure shows the rear of the chassis with three fan modules and one power supply
installed. The fan modules are numbered 1–3 from left to right, and the power supplies are
numbered PSU 1 on the left and PSU 2 on the right.
Installation fundamentals
October 2015 Installing the Avaya VSP 7200 Series 19
Comments on this document? infodev@avaya.com
To Next Page
Loading...
