Chapter 5: Installing the Avaya Virtual
Services Platform 7200 Series
This section provides the information and procedures to install the Avaya Virtual Services Platform
7200 Series.
Installation checklist
Use this checklist to install the Avaya Virtual Services Platform 7200 Series.
No. Task Description
1. Mount the Avaya Virtual Services
Platform 7200 Series in the
equipment rack.
See Installing the switch in an equipment
rack on page 40.
You have two options for installing the switch in
an equipment rack:
• Using the optional slide rack mount kit on
page 41
•
Using the supplied bracket on page 55
2. Install the primary or redundant
power supply.
Important:
Avaya does not support a
combination of AC-input and
DC-input power supplies in the
same chassis.
If you have an AC power supply, see Installing
an AC power supply on page 24.
If you have a DC power supply, see Installing a
DC power supply on page 29.
3. Install the fan modules. See Installing a fan module on page 34.
4. Check the LEDs to verify the
installation.
For a description of the LEDs, see LED state
definitions on page 36.
October 2015 Installing the Avaya VSP 7200 Series 18
Comments on this document? infodev@avaya.com
To Next Page
Loading...
