Using the optional slide rack mount kit
The Universal Slide Rack Mount Kit is adjustable so that you can install your switch in equipment
racks of different sizes. Use the following procedures to install your switch in equipment racks with a
depth from 300mm to 900mm.
This kit is a separately ordered item (Part # EC8011002).
Note:
The illustrations show the VSP 7200 as an example, but the instructions apply to any switch in
the Avaya Virtual Services Platform 7200 Series and Avaya Virtual Services Platform 8000
Series.
For instructions see:
• Installing slides in a 300mm-600mm equipment rack on page 41
• Installing slides in a 600mm-900mm equipment rack on page 49
• Important notice about rack safety on page 54
• Removing the switch from an equipment rack on page 54
Warning:
If you pull the switch all the way out on the slide rails, there is a danger of the rack tipping over.
For more information and guidelines, see
Important notice about rack safety on page 54.
Installing slides in a 300mm-600mm equipment rack
Use the following procedure to install your switch in an equipment rack with a depth between
300mm and 600mm.
Procedure
1. Disconnect the power cord from the switch.
Installing the switch in an equipment rack
October 2015 Installing the Avaya VSP 7200 Series 41
Comments on this document? infodev@avaya.com
To Next Page
Loading...
