Avaya Virtual Services Platform 7200 Series - Page 40

Enterprise Device Manager (EDM) representation of physical LED
status
EDM displays the same LEDs that you see on the physical device.
Note:
LED blinking in EDM is representative of, but not identical to, the actual LED blinking rates on
the switch.
For more information about the LEDs and a description of the blinking rates, see the preceding LED
sections.
Installing the switch in an equipment rack
There are two ways to install the switch in an equipment rack. Refer to one of the following sections:
• Slide Rack Mount Kit-This is a separately ordered option that you can use to install your switch
in an equipment racks that range from 300mm to 900mm deep. For installation instructions,
see Using the optional slide rack mount kit on page 41.
• Brackets-The switch comes with brackets that you can install on the chassis.
For installation instructions, see Using the supplied bracket on page 55.
Before you begin
• Ensure that you have a space of 1.75 inches (4.45 centimeters) in height for each switch in an
EIA or IEC-standard 19-inch (48.2-centimeter) equipment rack.
• The rack is bolted to the floor and braced if necessary.
• The rack is grounded to the same grounding electrode used by the power service in the area.
The ground path must be permanent and must not exceed 1 Ohm of resistance from the rack
to the grounding electrode.
About this task
Caution:
When you mount the device in a rack, do not stack units directly on top of one another. You
must secure each unit to the rack with the appropriate mounting brackets. Mounting brackets
cannot support multiple units. For a translation of this statement, see Translations of safety
messages on page 60.
Installing the Avaya Virtual Services Platform 7200 Series
October 2015 Installing the Avaya VSP 7200 Series 40
Comments on this document? infodev@avaya.com