The Fan IDs are assigned from left to right as you face the back of the chassis. For the first fan
module on the far left, the Fan IDs are 1 and 2, the next fan module has Fan IDs 3 and 4, and
the fan module on the far right has Fan IDs 5 and 6.
VSP-7254XSQ:1>show sys-info fan
Fan Info :
Fan Id Fan Status Fan Type FanFlowType
--------------------------------------------------------
1 up regularSpeed front-back
2 up regularSpeed front-back
3 up regularSpeed front-back
4 up regularSpeed front-back
5 up regularSpeed front-back
6 up regularSpeed front-back
Check the internal temperature of the switch.
Note:
The output of this command is different between the VSP 7254XSQ and the VSP 7254XTQ. An
example of both is shown below.
VSP-7254XSQ:1>show sys-info temperature
Temperature Info :
CPU Temperature MAC Temperature MAC2 Temperature
25 34 29
VSP-7254XTQ:1>show sys-info temperature
Temperature Info :
CPU Temperature MAC Temperature PHY1 Temperature PHY2 Temperature
28 38 32 30
LED state definitions
The figures and tables in the following sections describe the LEDs on the Avaya Virtual Services
Platform 7200 switch. The tables describe LED operation for a switch that finishes the power-on
self-test.
Warning:
Fiber optic equipment can emit laser or infrared light that can injure your eyes. Never look into
an optical fiber or connector port. Always assume that fiber-optic cables are connected to a light
source.
Switch LEDs
The following table describes the main switch LED state indications provided by LED color and
fluctuation cues.
Installing the Avaya Virtual Services Platform 7200 Series
October 2015 Installing the Avaya VSP 7200 Series 36
Comments on this document? infodev@avaya.com
To Next Page
Loading...
