Avaya Virtual Services Platform 7200 Series - LED State Definitions; Switch Leds

Procedure
1. Check the Fan LED on the front of the chassis. Solid green indicates that all fan modules are
operating normally. Blinking amber indicates that a fan module failed.
2. Enter the following command to determine which fan module failed.
show sys-info fan
This command shows the status of each fan module: up, down, or Not Present when a
fan is removed.
3. Remove the fan module that failed by pushing the tab on the spring latch to the left and
pulling on the fan’s extraction handle.
4. Insert the new fan module into the chassis.
Important:
You can hot swap fan modules while the switch is operational.
5. Verify that the fan module is fully seated in the chassis. The spring latch should engage and
return to its original position.
6. Enter the following command to check the temperature sensors inside the switch.
show sys-info temperature
Example
Check the status of the fan modules.
Note:
There are three fan modules in the VSP 7200 Series and each fan module has two fans for a
total of six fans. Each fan has its own ID and the show sys-info fan command reports its
status.
Installing a fan module
October 2015 Installing the Avaya VSP 7200 Series 35
Comments on this document? infodev@avaya.com