Note:
After you install the switch in a rack, slide it out until the lock (shown above) engages.
To slide the switch back into the rack, push the blue locks on the chassis rails towards
the back and slide the switch into the frame.
7. Connect power and network connections to the switch.
Installing slides in a 600mm-900mm equipment rack
Use the following procedure to install your switch in an equipment rack with a depth between
600mm and 900mm.
Procedure
1. Disconnect the power cord from the switch.
2. Detach the chassis rail from the slide’s rack rail. (See Step 2 of Installing slides in a
300mm-600mm equipment rack on page 41.)
3. Lift the locking mechanism on the rack rail to slide the outer section back into the main
section. (See Step 3 of the 300mm-600mm instructions.)
4. Attach the chassis rail to the chassis. (See Step 4 of the 300mm-600mm instructions.)
5. Remove the two screws and nuts securing the short rear bracket to the rack rail. This
bracket is for 300mm-600mm equipment racks only and is not used in this installation. Save
the bracket for possible future use.
Installing the switch in an equipment rack
October 2015 Installing the Avaya VSP 7200 Series 49
Comments on this document? infodev@avaya.com
To Next Page
Loading...
