6. Use the bag with 10 countersink screws and following steps to attach the supporting plates
to the rack rails:
a. Push the release lock up and slide the middle rail out as far as possible.
b. Orient the supporting plate over the holes in the rack rail.
c. Install the first two screws on one end.
d. Lift the locking mechanism and slowly slide the rail back into the main assembly. This
exposes a “window” over the screw holes so you can install the remaining three screws
one at a time.
Installing the switch in an equipment rack
October 2015 Installing the Avaya VSP 7200 Series 51
Comments on this document? infodev@avaya.com
To Next Page
Loading...
