www.factorybuysdirect.com
M130004/5-0112
MAINTENANCE CONT.
2a. Cleaning the Upper Filter Screen Frame
Clasp the wedging block of the EVA lter screen frame with hands. Force down
from the outside to remove the EVA lter screen frame. Unscrew four screws
holding the EVA lter screen to the rear housing to remove the EVA lter screen
(as shown in the gure 11).
2b. Put the EVA lter screen into warm water with neutral detergent (about 40°C/
104°F) and allow time to air dry after rinsing it clean.
POST-SEASON STORAGE:
1. Unscrew the drainage cover, unplug the water plug, and discharge the water
into the water pan or container.
2. Turn on the appliance, adjust it to low-wind ventilation mode, and maintain this
state until the drainage pipe becomes dry. Keeping the inside of the body in a dry
state will prevent it from mildewing and extend the life of your appliance.
3. Turn off the appliance, unplug the power plug, and wrap the power cord
around the wrapping post; install the water plug and the drainage cover.
4. Remove the exhaust pipe and store it properly.
5. Cover the air conditioner with a plastic bag. Put the air conditioner in a dry
place, keep it out of the reach of children, and take dust control measures.
6. Remove batteries of the remote control
NOTE: Ensure that the body is placed in a dry place and store all machine com-
ponents properly.
TROUBLESHOOTING
Do not repair or disassemble the air conditioner by yourself. Unqualied repair
will lead to failure of the warranty and may cause damage to users of their
property.
To Next Page