www.factorybuysdirect.com
3M130004/5-01
NOTES CONT.
3. Place the appliance in a at and dry place and keep a distance of above 20
inches between the machine and the surrounding objects or walls.
4. After the air conditioner is installed, ensure that the power plug is intact and
rmly plugged into the power outlet. Place the power cord to prevent someone
from being tripped or pulling out the plug.
5. Do not put any object into the air inlet and outlet of the air conditioner. Keep
the air inlet and outlet free from obstructions.
6. When drainage pipes are installed, ensure that the drainage pipes are prop-
erly connected, and are not distorted or bent.
7. While adjusting the upper and lower wind-guide louvers of the air outlet,
handle gently to avoid damaging wind-guide louvers.
8. When moving the appliance, make sure that it is in an upright position.
9. The appliance should stay away from gasoline, ammable gas, stoves and
other heat appliances.
10. Do not install and use the air conditioner in the bathroom or other humid
environments.
11. Do not pull the plug to turn off machine.
12. Do not place any objects on the air conditioner.
13. Do not use insecticide spray or other ammable substances near the air
conditioner.
14. Do not wipe or wash the appliance with chemical solvents such as gasoline
and alcohol. When you need to clean the air conditioner, you must disconnect
the power supply, and clean it with a half-wet soft cloth. If needed, scrub with a
mild detergent.
FEATURES
1. Modern appearance, compact, simple, and elegant.
2. Cooling, heating (select models), dehumidication, air supply and continuous
drainage function.
3. Automatic swing louver incorporates automatic air swing function. The outlet
can be covered when the appliance is turned off to prevent dust from entering the
body.
4. LCD displays control panel. High-quality LCD remote control is equipped to
facilitate operation. The remote control can be placed on the back of the body.
5. Handles on both sides allow for ease of portability.
6. A cord wrap is provided on the back of the appliance to keep the cord safe and
out of the way.
7. Outdoor interface is set high to facility assembly and keep the smooth ow of
the heat pipe. Outlet connection for the hose is high at the back of the heater to
facilitate heat exit and efciency.
8. Air ltration capability.
9. Timing switch function.
10. Appliance protection function of automatically restarting the compressor after
three minutes if a power failure happens.
To Next Page
Loading...