09
Step 1: Unpack the bike.
Open the bike box. With the help of another person capable of safely lifting a heavy object, remove the
ebike from the bike box. Carefully remove the packaging material protecting the bike frame and components,
as well as remove the small boxes attached to the fork. These are your charger and accessories. Please
recycle packaging materials especially cardboard and foam whenever possible.
Step3: Handlebar Installation.
Loosen the 2 screws in the stem, place stem onto the head tube with the display facing upwards,replace the
top cap and use 5mm hex key to securely tighten the handlebar. Reinsert the rubber cover backinto the top
cap.
Step 2: Preparing for handlebar installation.
Remove the stem rubber cover, loosen the bolt using 5mm hex key, and discard the plastic white
protective guard.
NOTICE: The following steps are only a general guide to assist in the assembly of your ebike and are
not a complete or comprehensive manual of all aspects of assembly, maintenance, and repair. Consult
a certified, reputable bike mechanic to assist with assembly, repair, and maintenance of your ebike.
ASSEMBLY
Rubber Cover
White Plastic Stem
Protective Guard
5mm Hex Key
To Next Page
Loading...
