EasyManua.ls Logo

aventon Aventure - Kickstand and Pedal Installation; Install Pedals

aventon Aventure
30 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
11
Caution: Never touch the brake rotor, especially when the wheel and/or bike is in motion, or serious injury
could occur. Hand oils can cause squeaking and decrease brake performance
WARNING: An improperly secured front wheel and/or handlebar stem can cause loss of control, accidents,
serious injury, or death. Check that the front wheel and handlebar stem are properly secured to the bike
during assembly and before each ride.
Step 5: Front fender installation.
A.Use 4mm hex key to loosen front fork screws.3pcs)
B.Align front fender to the screw holes, use 4mm hex key to tighten front fork screws. (3 pcs)
Step 6:Put down kickstand to support the ebike.

Related product manuals