Your cables, spokes, and chain will stretch after an initial break
-in period of 50-100 mi
(80-160 km), and bolted connections can loosen. Always have a certified, reputable bik
e
mechanic perform a tune-up on your LEVEL after your initial break
-in period of 50-100 mi
(80-160 km) (depending on riding conditions such as total weight, riding characteristics,
and terrain). R
egular inspections and tune-ups are particularly important for ensuring that
your bik
e remains safe and fun to ride.
It is critically important that proper air pressure is always maintained in pneumatic tires. Do
not underinflate or overinflate your tires. L
ow pressure may result in loss of control, and
overinflated tires may burst. Failure to always maintain the air pressure rating indicated on
pneumatic tires may result in tire and/or wheel failure
.
Inflate your tires from a regulated air source with an available pressure gauge
. Inflating your
tires from an unregulated air source could overinflate them, resulting in a burst tire.
Even tires equipped with built-in flat-preventative tire liners, lik
e those that come with bik
es
by A
venton Bik
es, can and do get flats from punctures, pinches, impact, and other causes.
When tire wear becomes evident or a flat tire is discovered, you must replace the tires and/or
tubes before operating the bik
e or injury to operators and/or damage to your bike could occur
.
When changing a tire or tube
, ensure that all air pressure has been removed from the inner
tube prior to removing the tire from the rim. Failure to remove all air pressure from the inner
tube could result in serious injury
.
Using aftermarket tires or inner tubes, not provided by Aventon Bikes may void your warranty
,
create an unsafe riding condition, or damage to your bik
e by Aveton Bikes. If required by law
,
ensure replacement aftermark
et tires have sucient reflective sidewall striping.
For more information on tire or tube replacement procedures, or questions about tire inflation,
contact A
venton Bikes Product Support.
Email: info@aventon.com or Call: 1-866-300-3311
Tire Informatio
n
LEVEL uses 27.5’’ x 2.2’’ rubber tires with inner tubes. The tires are designed for durability and safety for
regular cycling activities and to be checked before each use for proper inflation and condition. Proper
inflation, care, and timely replacement will help to ensure that your bike’ s operational characteristics will
be maintained, and unsafe conditions avoided.
Aventon Bikes recommends 50-80 psi/1.4 bar for the stock tires on LEVEL. Always stay within the
manufacturer’ s recommended air pressure range as listed on the tire sidewall.
27
To Next Page
Loading...
