14
Step 13: Remove motor protector and put on the motor protection guard on both sides of back wheel.
Note: Part of plastic motor protector will likely break and be left in between the frame and the gears, use a pair of
pliers to carefully remove it.
Step 14:
Inflate the tires. Check that the tire beads and tires are evenly seated on the rims. Use a pump with a Schrader
valve and pressure gauge to inflate each tire to the recommended pressure indicated on the tire sidewall, 30-50PSI (2.0-3.5
BAR).Do not overinflate or underinflate tires.
Step 15:
Set the desired seat height. Open the quick release lever by hinging it open fully. Adjust the seatpost up or
down to a comfortable height, while ensuring the seatpost is inserted into the frame past the minimum insertion point.
If needed, use the thumb nut to add tension to the clamp so there is some resistance when the lever is in line with the
clamp bolt, but do not overtighten. Close the quick release lever to secure the seatpost and check that it cannot move.
See the Adjusting the Seat section of this manual for more details.
To Next Page
Loading...
