13
Step 9: Inflate the tires.
Check that the tire beads and tires are evenly seated on the rims. Use a pump with
a Schrader valve and pressure gauge to inflate each tire to the recommended pressure indicated on the tire
sidewall, 50-80PSI. Do not overinflate or underinflate tires.
Step 10: Set the desired seat height. Open the quick release lever by hinging it open fully. Adjust the
seatpost up or down to a comfortable height, while ensuring the seatpost is inserted into the frame past the
minimum insertion point.
Step 8: Remove motor protector and put on the motor protection guard on both sides of back wheel. Then
press the rubber caps on both sides. (Rubber caps are in the accessories box)
Note: Part of the plastic motor protector may break and will be left inside the freewheel. Use a pair of pliers
to carefully remove it.
To Next Page
Loading...
