AVer EH6108H - Familiarizing the Remote Controller Buttons

16
1.5 Familiarizing the Remote Controller Buttons
Use the Remote controller to operate the DVR unit.
Name
Function
(1)
Switch to playback mode
(2)
Start recording video
(3)
To call out system setup menu
(4)
To rewind the recorded video
(5)
To start playback
To pause playback
(6)
To playback video at faster speed
(7)
To select the time and date of playback file
(8)
Set a playing recorded video from A point to B point
segment and repeat playing on surveillance screen
(9)
To backup recorded video file to USB storage device(pen
drive or external hard disk) and DVD-ROM.
(10)
To reset alarm status
(11)
Switch to Emap mode
(12)
Switch to PTZ mode. Press + channel number
( ~ ) can switch to PTZ control mode if the
selected camera is a PTZ camera and the PTZ function is
enabled.
Name
Function
(13)
A functional key for multiple system control
-
Press to enable FN modes (The word “
FN
” will show up in the left bottom
corner on screen).
-
To exit FN modes, press again (The “
X
” will show up in the left bottom
corner on screen).
+ : Switch to single screen display mode
+ : Switch to QUAD display mode
+ : Switch to 9 spilt screen display mode
+ : Switch to 16 spilt screen display mode