- Start Recording
Record the video from the selected camera.
1. Beside the Start Recording check box, click
Detail.
2. In the Alarm Recording Setting dialog box,
select the camera to enable/disable video
recording. Enable All to select all cameras.
3. In the Frame Rate selection, select As Setting
to record the number of frames based on the
Recording Setting.
4. In the Start Record prior text box, mark and set
the number in second for the program to begin
recording before the alarm has been trigger. The
time range is 1~10 seconds.
5. In the Stop Record after text box, mark and set
the number in second for the program to continue recording after the alarm has ended. The time
range is 1~999 seconds. If user doesn’t mark and set the time, the alarm recording will continue
recording until alarm is reset.
6. Click OK to accept the new settings and Cancel to exit without saving.
- PTZ preset point
Position the PTZ camera based on the preset point setting.
Beside the PTZ preset point check box, click Detail. In the
Trigger PTZ Preset Setting dialog box, select the PTZ camera
number then select the Enable check box. Select the position of
the PTZ camera when the alarm is activated and ended. For the
PTZ camera end point, user can also select on preset position
or Auto Pan between preset position groups.
- Send to CMS (Central Management System)
Enable/disable the selected camera to send video to
CMS when the alarm is activated.
Beside the Send to CMS check box, click Detail. In the
CMS Setting, select the camera to enable/disable
sending the video to CMS. Enable All to select all
cameras. Then, click OK to accept the new settings and
Cancel to exit without saving.
To Next Page
Loading...
