05/09 Rev. 5.02-01 OPERATING MANUAL Device Description
ALX 92x
12
Message mode The device uses status reports to signal an error or a particular operating sta-
tus. This message mode indicates that the device is waiting to quit or for fault
clearance. When quitting, the device switches from message mode to offline
mode (depending on the error and the progress of the last active process).
Messages are made up of the status number and a brief descriptive text:
The status message 5001 (shown above) occurs when for example the device
is set for punched label material, but continuous form material without punches
has been inserted. In this case, the device will continue to feed the material for
a few seconds before it generates an error message.
Status Reports : see topic section „Status Reports“.
Standalone mode In standalone mode, print jobs are not transferred but saved on a plugin card.
They are started directly from the devices operator panel or via a connected
keyboard.
Details about standalone mode: see topic section „Advanced Applications“,
chapter Standalone Operation on page 8.
Status 5001
No gap found
To Next Page
Loading...
