Avery Dennison ALX 92x - Basic Operating Procedures; Connecting the Device

05/09 Rev. 5.02-01 OPERATING MANUAL Device Description
ALX 92x
13
Basic operating procedures
Connecting the device
1. Ensure that the power switch is set to “0” (off).
2. Connect the device to the mains using the shipped power cable [7B].
¯ ALX 92x AI Pro: Device must be connected to the mains with two power
cables [7B,C].
[7] Sockets for the Centronics cable (A) and power cable (B) on the ALX 92x.
3. Using the data cable supplied, connect the Centronics interface [7A] on the
device to the host computer.
4. Turn on the device using the power switch (set to position “1”).
WARNING!
The device operates using mains voltage! Touching electrically live parts
may expose you to hazardous electrical currents and may lead to burns.
« Make sure that the device is switched off before connecting the power
cable.
« Only operate the device using the system voltage indicated on the na-
meplate.
« Only connect the device to a grounded power socket fitted to authori-
sed standards.
« The power cable should be run to the device so that a) nobody will trip
on it, and that b) the power plug can easily be pulled out if necessary.
« The power cable should not be more than 3 meters long.
« To disconnect the device completely, the power cable
(ALX 92x AI Pro: both power cables) has/have to be pulled off.
A
B
A
B
C