05/09 Rev. 5.02-01 OPERATING MANUAL Device Description
ALX 92x
11
Operating modes
Offline mode Settings can be made when the device is offline. The offline mode is normally
active when the device is switched on. Print jobs are received via the selected
interface but not processed.
No jobs are waiting to be processed:
To configure the device so that it goes directly into online mode when switched
on, set the parameter SYSTEM PARAMETER > Turn-on mode to “Online”.
Online mode In online mode, print jobs are received and processed immediately. Possible
messages:
• No jobs are waiting to be processed:
• The current data transfer to the printer is shown on the display. This is in-
dicated by the dot on the bottom right next to the number of loaded jobs.
Another point on half line height above the first shows the interpreter sta-
tus:
– No point: No data to interpete.
– Solid point: The interpreter is busy (still data left in the spooler).
– Flashing point: The interpreter is waiting for data required to complete
a command (no data in the spooler).
• During printing, the display also shows the number of print jobs read (13)
and the remaining number of labels (25) to be printed in the current job.
• If a print job recognises an endless number of labels to be printed, then the
remaining number for this job is also shown as endless.
¯ To stop printing, press the online button.
OFFLINE 0 JOBS
ONLINE 0 JOBS
ONLINE 0: JOBS
ONLINE 13 JOBS
Remainder: 25
ONLINE 13 JOBS
Remainder: endless
To Next Page
Loading...
