05/09 Rev. 5.02-01 OPERATING MANUAL Device Description
ALX 92x
14
5. Hold the on / off switch in the operator panel depressed for approx. 2 sec-
onds. The following sequence of messages is displayed:
The boot loader is starting:
Valid firmware recognised, program is starting.
Device type, version number of the machine firmware:
64 MB internal RAM
32 MB optional RAM on the CompactFlash card – only displayed when a
CompactFlash card is in use.
Offline mode
Online mode. The unit is ready for printing.
¯ When the parameter SYSTEM PARAMETER > Turn-on mode is set to “Offline”,
the device switches directly to offline mode when turned on.
¯ CAUTION! - Wait at least 10 seconds between switching the device off and
on again, otherwise any modified parameter settings are not saved.
Setting the interface
According to the factory settings, the ALX 92x is set for data transfer via Cen-
tronics interface. Print data can also be transferred via the serial interface,
USB or Ethernet interface.
« The interface type is selected with the following parameter:
INTERF. PARAM. > EASYPLUGINTERPR > Interface
¯ You might have to set other parameters as well, depending on the interface
chosen:
• Settings for the Centronics interface: INTERF. PARAM. > CENTRONICS
• Settings for the serial interface (COM1): INTERF. PARAM. > COM1
• Settings for the Ethernet interface: INTERF. PARAM. > NETWORK PARAM.
Setting parameters : see topic section „Info-Printouts and Parameters“,
chapter “Using the Parameter Menu”.
Data cables : Ordering nubers can be found in the Service Manual, topic sec-
tion „Spare Parts“, chapter „Accessories“.
System start...
System start...
Start user prog
ALX 924
V 5.33
Memory: 64 MB
Flashcard: 32 MB
OFFLINE 0 JOBS
Initialisation
ONLINE 0 JOBS
To Next Page
Loading...
