05/09 Rev. 5.02-01 OPERATING MANUAL Device Description
ALX 92x
21
Density If the printout is not as black as you would like it to be, increase the print den-
sity as follows:
1. Press the Esc button while in online mode. Display:
2. By pressing the Apply / Feed buttons, you can increase or decrease the
heat energy of the printhead (in %).
¯ The heat energy should be kept as low as possible while retaining an ac-
ceptable printing result. A high level of heat energy reduces the lifespan of the
printhead.
Print contrast
60%
To Previous Page
Loading...
