05/09 Rev. 5.02-01 OPERATING MANUAL Device Description
ALX 92x
4
[2] ALX 92x operating parts
A Insert diagram
Shows the path of the labelling material and ribbon
B Ribbon unwinding mandrel
Holds the new ribbon roll
C Ribbon rewinding mandrel
Holds the ribbon core onto which used ribbon is wound
D Adjustment knob for printhead pressure
For adjusting the printhead pressure to suit the material strength / width
E Adjustment wheel for label sensor
Turning the wheel moves the label sensor at right angles across the mate-
rial path
F Material guide
Guides the material path from both sides; the material end sensor is locat-
ed on the inner side
A
B
C
D
E
F
To Next Page
Loading...
