05/09 Rev. 5.02-01 OPERATING MANUAL Device Description
ALX 92x
6
E Power socket
Mains connection of the machine
F (ALX 92x AI Pro only) Power socket
Mains connection of the Applicator Interface „AI Pro“.
G Ethernet interface
To connect to an „Ethernet 10/100 Base T“ network
H Status-LED/Ethernet
I RS232 interface
For serial transfer of print data
J Centronics interface
For parallel transfer of print data (cable is inclusive)
K 2x USB interface type B (device)
To connect devices (e.g. keyboard, scanner)
L USB interface type A (host)
For transfer of print data
M Card slot
For CompactFlash cards; used for storing fonts, logos, graphics, etc.
N (Option) Second card slot
O (Option) Cable duct for OD control
To connect a photoelectric barrier, which checks the outer diameter of the
label material roll
P Card slot
– For SD/MMC cards
– Is not yet supported
Q (Option) Signal interface USI
– 4 inputs / 8 outputs
– 24 V signal voltage
To Next Page
Loading...
