Monarch and 9855 are registered trademarks of Avery Dennison Corp.
TC9855RFIDQR Rev. AU 5/15 2007 Avery Dennison Corp. All rights reserved.
QUICK REFERENCE
This Quick Reference contains supply loading and general
maintenance procedures for the Monarch® 9855® RFID
printer. Additional RFID documents are available on the
Monarch® Printer’s Documentation CD-ROM and on our
Web site (www.monarch.averydennison.com
). Refer to the
RFID Setup Utility at
http://www.servisource1.com/prnutil/rfidsetup for
illustrations to determine which type of RFID supplies you
are using and basic printer configuration information. For
information about creating formats, configuring the printer,
or programming the printer, refer to the Packet Reference
Manual available on our Web site.
Note: Information in this document supercedes
information in previous versions. Check our Web
site for the latest documentation and release
information.
The limited warranty on knives used in or with
RFID printers is one (1) year from the date of
shipment, or 500,000 cuts, whichever occurs first.
RFID Overview
Your printer has been engineered to program (encode) an
RFID (Radio Frequency Identification) label (commonly
called “RFID tags”) before the label’s format is printed.
RFID tags contain an embedded RFID inlay (chip and
antenna).
RFID is only available using die cut or black mark supplies.
Linerless supplies are not currently supported. The RFID
printer is also capable of printing standard (non-RFID)
supplies.
The printer supports Class 1 Generation 2 (C1Gen2)
protocol encoding.
To Next Page
Need help?
General
